Zte ZXR10 GER, Руководство пользователя

Страница: 329 / 412

Chapter 21 VPWS Configuration
Confidential and Proprietary Information of ZTE CORPORATION 307
T
A B L E
3 4 8 M
P L S
X
C O N N E C T
C
O M M A N D
Command
Format Command
Mode
Command Function
mpls
xconnect
neighbor-
id vcid
interface This enables the VPWS
Result: This enables the VPWS.
E
ND OF STEPS
Example: As shown in Figure 108, configuration of interface
address and loopback interface is in PE1
、
P
、
PE2. Run IGP
protocol such as OSPF protocol between PE1
、
P and PE2.
Configuration of MPLS is in PE1
、
P
、
PE2 and configuration of
router id is configured for mpls ldp. Configuration is done for
target session in PE1
、
PE2
，
make PE1 and PE2 to became the
neigbhour to each other. Configure the mpls xconnect command
in the interface which is connected to the CE in PE1 and PE2.
F
I G U R E
1 0 8 V
P W S
S
E R V I C E
Fei_1/2
Fei_3/1
Fei_2/1
Fei_2/2
Fei_4/1
Fei_1/1
Fei_3/2
Fei_5/1
PE1 P PE2
CE1 CE2
PE1 configuration:
PE1(config)#interface loopback10
PE1(config-if)#ip address 1.1.1.1 255.255.255.255
PE1(config)# interface fei_1/1
PE1(config-if)#mpls xconnect 1.1.1.3 100
PE1(config)#interface fei_1/2
PE1(config-if)#ip address 175.1.1.1 255.255.255.0
PE1(config-if)#mpls ip
PE1(config)#mpls ip
PE1(config)#mpls ldp router-id loopback10 force
PE1(config)#mpls ldp target-session 1.1.1.3
PE1(config)#router ospf 1