Zte ZXR10 GER, Руководство пользователя

Страница: 281 / 412

Chapter 17 Policy Routing Configuration
Confidential and Proprietary Information of ZTE CORPORATION 259
exist, the router selects the first valid default egress
according to the sequence.
„
If set default interface is not set or no valid set default
interface exists, the router forwards the message according
to the default route.
„
If no default route is specified in the system, the router
discards the message.
NOTE: In the ZXR10 GER, the path selection modes for
message forwarding are prioritized as policy routing>normal
routing>default routing.
Configuring Policy Routing
Refer to below procedure for PBR configuration on ZTE ZXR10
GER routers.
Router Command Line Interface has been accessed.
1. To create a route-map policy, use
route-map command in
global configuration mode, as shown in Table 305.
T
A B L E
3 0 5 R
O U T E
M
A P
C
O M M A N D
Result: This creates a route-map policy.
2. To implement the route map policy, use match / set
command in the route mapping configuration mode, as
shown in Table 306.
T
A B L E
3 0 6 M
A T C H
/ S
E T
C
O M M A N D
Result: This implements the route map policy.
3. To perform policy routing on the data packet that matches
the access table, use match ip address command in route
mapping configuration mode, as shown in Table 307.
Purpose
Prerequisite
Steps
Command
Format
Command
Mode
Command Function
route-map privileged
This creates a route-map
policy
Command
Format
Command
Mode
Command Function
match / set
route
mapping
configuration
This implements the route
map policy