16
To setup a static connection, perform the following steps.
IPv4 static connection is used as an example.
a) Select
Route
from the
Type
drop-down list.
b) Select
IP
from the
Link Type
drop-down list.
c) Select
Static
from the
IP Type
drop-down list.
d) Specify the IP address, subnet mask, gateway, and DNS server in the
IPv4
area.
e) Specify other parameters as required, and then click
Next
.
3. Click
Next
to open the page, as show in
Figure 4 WiFi Configuration
describes the parameters for WiFi configuration.
Table 4 WiFi Configuration
Parameter
Description
Wireless RF Mode
Select
Enabled
to enable the wireless RF function.
Country/Region
Select the country or region.
Name SSID
Specify the SSID name.
Authentication Type
Select the authentication type.
The provides the following access authentication modes:
Open System: Authentication is not needed. Any client
with a wireless network card can connect to the wireless
access point.
Shared Key: This mode provides WEP encryption.
WPA-PSK: WPA-PSK is a version of WPA. It uses the
pre-shared key. WPA-PSK is similar with WEP but it is
securer. The data is encrypted before transmission.
WPA2-PSK: It is the second version of WPA-PSK.
