Zte ZXG10 iBSC, Руководство по установке оборудования

Страница: 93 / 169

Chapter 6 Cable Installation
Figure 6-29 Ethernet cable structure For FE electric ports
l For GE electric port, Ethernet cable uses CAT6 unshielded twisted pairs (UTP)
network cable.
l For GE optical port, Ethernet cable uses single mode optical fiber.
Steps
1. Connect End A of the cable.
l For FE electric port, end A is inserted at RMNIC FE1~FE4 on BIPI.
l
For GE electric port, end A is inserted at RGER GE1 on GIPI.
l For GE optical port, end A is inserted at TX RX on GIPI panel.
2. Connect End B of the cable.
l
For FE electric port, end B provides standard RJ45 positive interface, connecting
to distribution frame provided by office or directly connecting to opposite side.
l
For GE electric port, end B provides standard RJ45 positive interface, connecting
to distribution frame provided by office or directly connecting to opposite side.
l
For GE optical port, end B provides standard LC/PC interface, connecting to
distribution frame provided by office or directly connecting to opposite side.
– End of Steps –
6.10.4 Installing STM-1 Fiber
Context
Implement the STM-1 optical fiber connection between ZXG10 iBSC and BTS/MSC/MGW.
Both ends of fiber structure are LCP/PC connector without direction.
The fiber shall be in pairs.
Steps
1. For one optical fibre,
one end of STM-1 optical fiber is connected with optical port ‘TX’ on SDTB/SDTB2
front panel, the other end is connected with ‘RX’ on peer equipment;
2. for the other optical fiber,
6-39
SJ-20110531095035-004|2011-10-28 (R2.0) ZTE Proprietary and Confidential