FCC RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
During SAR testing, this device was set to transmit at its highest certified powe
separation of 10 mm. Although the SAR is determined at the highest certified power level, the
device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the cl
output.
The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR.
This device is complied with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1
specified in IEEE1528.
The FCC has granted an Equipment Authorization for this model device
device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC I
For this device, the highest reported SAR value for usage near the body
While there may be differences between the SAR levels of various
SAR compliance for body-worn operation is based on a separation distance of
exposure level compliant or lower to the reported level. To support body
between this device and your body.
RF exposure compliance with any body-worn accessory, which contains metal, was not tested and certified, and using such body
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
interference received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the manufact
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This e
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, ther
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage
. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the
is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power
The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6
for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement methods and procedures
device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model
is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: SRQ-R218Z.
For this device, the highest reported SAR value for usage near the body is 1.340 W/kg.
While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirements.
worn operation is based on a separation distance of 10 mm between the unit and the human body. Carry this device at least 10 mm
exposure level compliant or lower to the reported level. To support body-worn operation, choose the belt clips or holsters, which do not contain metallic components, to maintain a separation of
worn accessory, which contains metal, was not tested and certified, and using such body-worn accessory should be avoided.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
located or operating in conjunction with any other antenna or transmitter.
h the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fr
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Communications Commission of the United States.
r level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body with the
actual SAR level of the device while operating can be well below the maximum value. This is because the
eless base station antenna, the lower the power
The SAR limit set by the FCC is 1.6 W/kg.
1992 and had been tested in accordance with the measurement methods and procedures
eported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model
10 mm away from your body to ensure RF
worn operation, choose the belt clips or holsters, which do not contain metallic components, to maintain a separation of 10 mm
worn accessory should be avoided.
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
quipment generates, uses and can radiate radio frequency energy and, if not
e is no guarantee that interference will not occur in a particular
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
