Zte H298N, Руководство по обслуживанию

Страница: 41 / 133

Table 10 IEEE 802.11n Only Parameters
Parameter Description
Wireless RF Mode Select Enabled to enable the wireless RF function.
Enable Isolation When you select this check box, the subscribers with different
SSIDs cannot visit each other.
Mode Select the working mode according to the wireless network card
configuration.
Country/Region Select the country or region.
Band Width You can select 20Mhz or 40Mhz.
Channel The default is Auto.
SGI Enable Select this check box to enable the short GI function.
Beacon Interval Time interval for the wireless device to broadcast the SSID
Keep the default value.
Transmitting Power Select the transmitting power as required.
QoS Type Type of QoS
RTS Threshold Specify the Request to Send threshold for a packet. When a
packet exceeds this value, the device sends the RTS value to the
destination point for negotiation. The default is 2347.
DTIM Interval The value range is from 1 ms to 5 ms. The default is 1 ms.
3. Click Submit .
4.2.2 SSID Settings
Perform this procedure to configure multiple SSIDs.
The ZXHN H298N can be specified with four SSIDs and each SSID supports up to 32 subscribers.
Steps
1. Choose [ Network→ WLAN→ SSID Settings ].
2. Select an SSID from the Choose SSID drop-down list, as shown in Figure 26 .
41