11
• Power off your phone before you clean the phone. Please use clean fabric that is anti-static to clean your phone.
• As your mobile phone can produce electromagnetic field, do not use the phone near electrical appliances.
• Do not charge the mobile phone without battery.
• Beware of the usage limitation when using a mobile phone at places such as oil warehouses or chemical factories.
• The user is cautioned that changes or modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment
.
Warranty Terms
The warranty does not apply to defects or errors in the product caused by:
(a) Reasonable abrasion.
(b) Misuse including mishandling, physical damage, improper installation, unauthorized disassembly of the product.
(c) Water or any other liquid damage.
(d) Any unauthorized repair or modification.
(e) Power surges, lightning damage, fire, flood or other events outside ZTE’s reasonable control.
(f) Use of the product with any unauthorized third party products such as generic chargers.
(g) Any other cause beyond the range of normal usage for products.
End User shall have no right to reject, return, or receive a refund for any product from ZTE under the
above-mentioned situations.
This warranty is end user’s sole remedy and ZTE’s sole liability for defective or nonconforming items, and is in lieu of
all other warranties, expressed, implied or statutory, including but not limited to the implied warranties of
merchantability and fitness for a particular purpose, unless otherwise required under the mandatory provisions of the
law.
Limitation of Liability
ZTE shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from
or arising out of or in connection with using this product, whether or not ZTE had been advised, knew or should have
known the possibility of such damages.
Radio Frequency
（
RF
）
Energy
•
This model device meets the government’s requirements for exposure to radio waves.
•
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S. Government.
•
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate
or SAR. The SAR limit set by the FCC is 1.6W/kg.
*Tests for SAR are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at
the highest certified power level, the actual SAR level of the device while operating can be well below the
maximum value. This is because the device is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower
the power output.
•
The highest SAR value for the model device as reported to the FCC when worn on the body, as described in this
