Zotac nForce 790i-Supreme, Руководство пользователя

Страница: 20 / 96

9
8-pin ATX 12V Power (PWR2)
PWR , the 8-pin ATX 12V power connection, is used to provide power to the CPU.
Align the pins to the connector and press firmly until seated.
Connecting IDE Hard Disk Drives
The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.
1. Connect the blue connector (the cable end with a single connector) to the
motherboard.
2. Connect the black connector (the cable with the two closely spaced black and
gray connectors) to the Ultra ATA master device.
3. Connect the gray connector to a slave device.
If you install two hard disk drives, you must configure the second drive as a slave
device by setting its jumper accordingly. Refer to the hard disk documentation for the
jumper settings.
Note: If an ATA-66/100/133 disk drive and a disk drive using any other IDE
transfer protocol are attached to the same cable, the maximum transfer
rate between the drives may be reduced to that of the slowest drive.
Hardware Installation