ZORA P1, Руководство пользователя

Страница: 30 / 30

30
6 Pass the four case
screw ⑨ through the
upper and lower plates
of
the housing
according to the
position and direction
shown in the figure;
Screw the four case
nuts ⑩
into the
corresponding screws
respectively according
to the position and
direction shown in the
figure
and tighten
them.
7 Finish.
11.1.3 Other description
If you need to install and deploy other development board accessories or
peripherals on the housing (such as the eMMC memory card fan for the Obi MID-Light
3D camera, etc.), please refer to the installation instructions for the corresponding
accessories.
11.2 The power adapter
11.3 RTC
11.4 Touch module and LCD display
11.5 Microphone array （ Far field pickup algorithm ， Noise reduction algorithm and
act）