4. The Smart Chime should disappear from your controller's device list
If the first attempt is unsuccessful, please repeat the process following all steps carefully.
FACTORY RESET
When your network
’
s primary controller is missing or otherwise inoperable, you may need to reset the
device to factory settings manually. To complete the process, make sure the Smart Chime is powered on,
then PRESS AND HOLD the Z-Wave button for AT LEAST 10 SECONDS until the LED indicator flashes ONCE.
Release the button. NOTE: All previously recorded activity and custom settings will be erased from the
device
’
s memory.
MOUNTING
There are 2 ways to install the Smart Chime:
1. Use the supplied screw to fix the Chime on the wall or surface of your choice (recommended). The
screw is inserted to a dedicated opening on the back plate of the Chime. Once the screw is in, pull the
Chime down a notch to lock it in place.
OR
2. Use the included adhesive tape to stick the Smart Chime to the surface of your choice.
WARNING
- This product should be installed indoors upon completion of any building renovations
- Prior to installation, the device should be stored in a dry, dust-and-mold-proof place
- Do not install the Smart Chime in a place with direct sun exposure, high temperature or humidity
- Keep away from water, chemicals, and dust
- Ensure the device is never close to any heat source or open flame to prevent fire
- No part of the device may be replaced or repaired by the user, except for battery change
Z-WAVE PLUS CERTIFIED
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from other manufacturers and/or other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the network.
ADVANCED SETTINGS
If your
controller’
s software allows for advanced configuration and parameter adjustment, you will be
able to change and save the settings below and customize the Smart Chime according to your needs.
Siren Volume
Parameter 1: Choose from 3 volume levels for the alarm siren sound. Set volume to low, medium, or high.
Values: 1
–
low, 2
–
medium, 3
–
high (default)
