Zontes ZT310T-M, Руководство по обслуживанию

Страница: 47 / 184

47 / 184
Radiator
●The vehicle must be parked on a flat and stable ground
or a lifting platform.
●Once the engine and muffler have cooled down, the
operation can be performed.
●Swallowing or inhaling the coolant will cause harm to
the human body.
●Regularly check the coolant level, and always keep the
position not lower than the "L" line.
●It is recommended to replace the coolant every 4 years
or 40,000 kilometers (24855 mile).
●Swallowing or inhaling the coolant will cause certain
harm to the human body. After each addition of coolant,
wash hands, face and any exposed skin thoroughly in
time. If swallowed by mistake, immediately contact the
poison control center or hospital; if inhaled, immediately
go to a ventilated environment. If it accidentally splashes
into the eyes, immediately rinse the eyes with a large
amount of running water and seek medical advice or
consultation in time. Keep away from children and pets.
●The engine coolant must be a model suitable for
aluminum radiators, based on ethylene glycol. Use a
coolant that is suitable for aluminum radiators, which is a
mixture of coolant concentrate and distilled water in a
certain proportion. If you need to add water, you can
only add distilled water. Other water quality may corrode
the engine cooling system or cause more serious
consequences.
●It is necessary to select the corresponding antifreeze
liquid according to the lowest possible local temperature.
The vehicle added to the factory is Total -35°C (-31F)
green antifreeze. The total amount of coolant is 1.64L
(1.73 US qt, 1.44 lmp qt, 0.43 US gal, 0.36 lmp gal).
●Coolant may damage the paint surface. Pay attention
when adding it. A small amount of splash should be
wiped off with a clean soft cloth immediately.
1. Check the coolant
a. Press the button on the right side of the front
storage box switch to open the right storage box cover.
b. After opening, buckle the rubber plug as shown in
the figure by hand, and be careful not to use sharp tools
or nails to buckle.
c. Right the vehicle and use a flashlight to observe
whether the liquid level of the Coolant expansion tank is
between "H" and "L". Pay attention to the ground as flat
and level as possible, do not inspect on the slope. And
the engine needs to be in a cold state.
d. Reinstall the rubber plug after checking. Close the
right storage box cover.
2. Add coolant (antifreeze) to the Coolant expansion
tank
If the water level of the Coolant expansion tank is
lower than the "L" line, an appropriate amount of coolant
must be added. If there is no coolant in the Coolant
expansion tank, check the cooling system for leakage
first, and it must be repaired before it can be
replenished.
a. Use 4# inner hexagon to remove the upper 2 bolts
⑴
, remove the bushing
⑵
and the cushion rubber
⑶
.
b. Remove the expansion nail
⑷
. For instructions on
disassembly and assembly of expansion nails, please
refer to the pre-service instructions in this chapter.