Zontes ZT310M 2022, Руководство по обслуживанию

Страница: 74 / 88

Drive shaft, output shaft, double gear check
1. As shown, ck drive shafts, output shafts and spline positions for bending, deformation and abnormal wear, if there is
any replacement.
（
Note: It is not recommended to press the drive shaft out of the 6205 bearing if there are no
obvious problems, pressing out the drive shaft will damage the 6205 bearing.
）
2, as shown, check the double gear assembly, output gears, drive shaft, whether there is abnormal wear, etched, if
there is any replacement.
Six, Gearbox assembly
Before the gearbox cover, remove the oil stains on the joint surface of the gearbox cover, and inspect the
joint surface of the gearbox cover, and require no scratches, bumps.
1, As shown, apply oil to the bearing surface of the left crankcase gear housing and insert the output shaft with the
output shaft retaining ring fitted into the corresponding position in the left crankcase (when the output shaft is installed
in place, the sound will sound), sequentially use the double gear assembly, The output shaft gear is installed in place.
FB35 × 54 × 7 fluorine oil seal
GB276-60 / 28-2RK deep groove ball bearings
GB276-62 / 22 / P5 deep groove ball bearings
GB276-6303-P5C3 deep
groove ball bearing
ZT1P72MN output shaft
ZT1P72MN drive shaft
Drive shaft slope
Output gear
ZT1P72MN double gear assembly