1. Use a base or pedestal of at least 150 lb (68 kg) with Powersol. This ensures the best stability and safety.
2. Do not drill holes through the pole, umbrella, solar panels, charging tower, or any other parts of Powersol.
3. Do not submerge Powersol’s charging tower in water.
4. When charging mobile devices with Powersol, only use USB cables that are approved by the device manufacturer.
5. Do not plug multi-purpose USB plugs or hubs into Powersol.
6. As stated in the Powersol warranty, improper assembly will void warranty.
NOTES
10
9
11
8
Hand-raise the umbrella canopy, and then lock the canopy
in the raised position by inserting the attached pin through
the hole in the umbrella pole.
To charge a USB device:
A. Slide the port cover to the left, then insert the USB
cable into the port.
B. The lower right LED will glow yellow while the device is
charging. When fully charged, the LED will turn green.
A
B
A
B
To show the charge level of the charging tower’s
internal battery:
Push and hold the button on the battery indicator panel.
When the internal battery is being charged, the four LEDs
will glow in rotation (from bottom to top).
When the battery level is very low, the lowest indicator
light will flash, indicating that the internal battery needs to
be charged. At that point, the three USB ports will be unus-
able until internal battery is charged.
To clean the umbrella fabric beneath a solar panel:
A. Unsnap the fabric loop that fastens the solar panel
to the umbrella.
B. Gently lift the solar panel away from the umbrella, and
clean the umbrella fabric.
C. When finished, insert fabric loop through the housing at
the end of solar panel, and snap tightly
.
C
