ZOLL AutoPulse 100, Руководство пользователя

Страница: 62 / 88

Page 4-2
User Guide
2. The Battery Charger automatically detects the presence of the Li-Ion Battery within 5 seconds.
3. The Battery Charger’s status will be indicated on the control panel (see Figure 4-2).
Figure 4-2 Battery Charger Control Panel
4. The Battery Charger will automatically perform a Test-Cycle when needed. This will automatically
occur at a minimum of once every 30 days (For more information, refer to the AutoPulse Power
System User Guide).
Note: Do not remove a Li-Ion Battery from the Battery Charger until its charging completes or the
Battery’s runtime will be reduced.
Note: Do not remove a Li-Ion Battery during a test-cycle or the Battery’s runtime will be unknown.
Removing a Battery during a Test-Cycle will cause the Battery Charger to automatically enter
a Test-Cycle mode the next time the Battery is inserted into it.
5. To remove a Battery from the Battery Charger, grip the Battery while pulling the finger latch out to
disengage the locking bar. Pull the Battery straight out until it fully clears the charging bay.
Note: Newly-charged Batteries can be warm to the touch. This is a consequence of normal operation.
4.2 Cleaning the Platform
1. Remove and dispose of the LifeBand.
2. Wipe all the surfaces of the Platform free of foreign matter and spills with a disinfectant or
bactericidal wipe. Check the vents to ensure that they are free and clear of any obstructive matter.
Caution: Do not submerge the Platform in liquid.
Caution: Do not autoclave the Platform, the LifeBand, or the AutoPulse Power System.
3. Ensure that the Platform is dry before storing.