ZOJE ZJ5820, Руководство по эксплуатации, Страница: 106 / 108

10. Appendix 1
Malfunction
Name of Malfunction Method for Settlement
code
E-029 Hammer can not go down Turn off machine to increase the knife pressure
E-030
Stepping board
communication abnormal
Turn off machine and check the device as below ：
1
、
Check the connection between the stepping
communication board and the mother board
；
2
、
Check the stepping board.
E-031 X motor running abnormal
Turn off machine and check the device as below ：
1 、 Check the communication cable of stepping
board
2
、
Check the stepping driving board
E-032 Y motor running abnormal
Turn off machine and check the device as below
：
1
、
Check the communication cable of stepping
board
2
、
Check the stepping driving board
E-033 Cloth board over--range
Turn off machine and check the device as below ：
1 、 Check the range of parameter. Make sure the
pattern parameters are not over the range of
presser
；
2 、 Check the cable connection between the
operation panel and the main control box.
E-034 Z motor running abnormal
Turn off machine and check the device as below ：
1
、
Check the connection of communication cable
on stepping board
；
2 、 Check the stepping driving board
E-035 Motor close loop abnormal
Turn off machine and check the device as below
：
1 、 Check the load at the main-shaft and the
blockage at the mechanism
；
2 、 Check the connection of main-shaft motor
cable
；
3 、 Check the main motor 。
E-036
Main-shaft 0 position signal
error
Turn off machine and check the device as below
：
1 、 Check the connection of main-shaft motor
cable
；
2
、
Check the main motor
；
3
、
Check the mother board
。
E-037 Main-shaft encoder error
Turn off machine and check the device as below
：
1 、 Check the connection of main-shaft motor
cable
；
2
、
Check the mother board
。
E-038 Main-shaft stop abnormal
Turn off machine and check the device as below ：
1 、 Check the installation and load of mechanism ；
2 、 Check the main motor 。
E-039 Sewing stop abnormal Turn off machine and check the device as below ：
97