NOTE: Ratings based on 1-1/4" pipe with friction loss neglected.
Using 3/4" garden hose adapter, performance will be reduced
approximately 15%. This pump does not deliver enough pressure to
operate lawn sprinklers properly.
OPERATION
1. Set pump on hard surface in water before starting.
2. Use the included garden hose adapater for 3/4" discharge line or
disconnect the adapter to use a 1-1/4" discharge.
3. Plug power cord into properly grounded 115 volt AC power
outlet. (See recommended grounding methods on front page).
Will operate continuously whether partly or fully submerged.
Submersible utility pumps are intended to pump water at
temperatures up to 104˚F (40˚C).
4. When the pump senses that it is no longer pumping water, the
pump will shut off automatically. The pump will then turn on every
three minutes for 5 seconds and then off if it does not sense any
water.
5. If water is sensed after the pump begins running, the pump will
continue pumping until the pump senses that it is no longer
pumping water.
6. To prevent unnecessary wear, unplug the pump from the power
output when not in use.
7. The pump is supplied with a 3/4" garden hose adapter. For use
with plastic pipe, remove the adapter and install the desired
1-1/4" NPT fitting. DO NOT OVERTIGHTEN THE HOSE OR
PLASTIC ADAPTER FITTING. Finger tight plus 1/2 turn is
sufficient.
Do not set pump directly on sand, dirt or mud.
Sand or mud-choked pumps can be back-
flushed clean.
Do not handle or carry the pump by the power
cord. Use the handle.
Extended usage of the pump in a partially
submerged or non-submerged situation may
cause the pump to overheat due to lack of heat dissipation from
the water. If this occurs, the pump will shut itself off until the motor
cools to its normal temperature. Repeated overheating may cause
damage to the pump.
MAINTENANCE
1. The motor housing of the pump is completely sealed and requires
no service. Disassembly of the motor housing or alteration of the
power cord voids all warranty.
2. The motor is a continuous duty type with an automatic thermal
overload protector device.
3. The pump can run against a partially restricted discharge, but
is designed to move large volumes of water with minimal back
pressure.
4. If the pump becomes clogged, remove the screen and clean out
the area.
5. Debris in the intake should be routinely removed from the bottom
of the pump to prevent damage to the pump, which will void the
warranty.
6. If necessary, remove the eight (8) screws holding the volute base
to the motor housing and clean the volute.
Manufacturer warrants, to the purchaser and subsequent owner during the warranty
period, every new product to be free from defects in material and workmanship
under normal use and service, when properly used and maintained, for a period
of one year from date of purchase by the end user, or 18 months from date of
original manufacture of the product, whichever comes first. Parts that fail within
the warranty period, one year from date of purchase by the end user, or 18
months from the date of original manufacture of the product, whichever comes
first, that inspections determine to be defective in material or workmanship, will
be repaired, replaced or remanufactured at Manufacturer's option, provided how-
ever, that by so doing we will not be obligated to replace an entire assembly, the
entire mechanism or the complete unit. No allowance will be made for shipping
charges, damages, labor or other charges that may occur due to product failure,
repair or replacement.
This warranty does not apply to and there shall be no warranty for any material
or product that has been disassembled without prior approval of Manufacturer,
subjected to misuse, misapplication, neglect, alteration, accident or act of God; that
has not been installed, operated or maintained in accordance with Manufacturer's
installation instructions; that has been exposed to outside substances including
but not limited to the following: sand, gravel, cement, mud, tar, hydrocarbons,
hydrocarbon derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive
substances, wash towels or feminine sanitary products, etc. in all pumping applica-
LIMITED WARRANTY
tions. The warranty set out in the paragraph above is in lieu of all other warranties
expressed or implied; and we do not authorize any representative or other person
to assume for us any other liability in connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky 40211,
Attention: Customer Service Department to obtain any needed repair or replacement
of part(s) or additional information pertaining to our warranty.
MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPECIAL,
CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH OF EXPRESSED
OR IMPLIED WARRANTY; AND ANY IMPLIED WARRANTY OF FITNESS FOR
A PARTICULAR PURPOSE AND OF MERCHANTABILITY SHALL BE LIMITED
TO THE DURATION OF THE EXPRESSED WARRANTY.
Some states do not allow limitations on the duration of an implied warranty, so
the above limitation may not apply to you. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state.
© Copyright 2011 Zoeller Co. All rights reserved.
MAIL TO:
P.O. BOX 16347 • Louisville, KY 40256-0347
SHIP TO:
3649 Cane Run Road • Louisville, KY 40211-1961
(502) 778-2731 • 1 (800) 928-PUMP • FAX (502) 774-3624
Your Peace of Mind is Our Top Priority
®
®
visit our web site:
www.zoeller.com
