background image

© Copyright 2014 Zoeller

®

 Co. All rights reserved.

The following will help assure longer pump life. If not completed or checked when pump is installed, the Limited warranty 

may be affected.

 

A. The voltage at the supply cord termination point must be 90% or greater than motor rated voltage when pump is

 running.

B. The power cord must be terminated in a NEMA 3R or 4X disconnect box per the NEC.

C. Pump must be mounted within 10 degrees of vertical.

D. Pump must be anchored to stop torquing while running, starting or stopping, relative to the float or anchor point.

E. Pump must be under water at all times and pump fluids with less than 3% solids.

G. The pump must be maintained on a regular basis. (De-scaled regularly to prevent deposits from stalling unit).

  EASY DO’S & DON’T’S FOR INSTALLING AGRICULTURAL PUMPS 

 1.

 DO

 read thoroughly all installation material provided with the pump.

 2.

 DO

 inspect pump for any visible damage caused by shipping.  Contact dealer if pump appears to be damaged.

 3. 

DO

 clean all debris from sumps.  Be sure that the pump will have a hard, flat surface beneath it.

    DO NOT

 install on sand, gravel or dirt.

 4.

 DO

 be sure that the sump is large enough to allow proper clearance for the level control switch(es) to operate 

properly.

 5.

 DO 

make certain pump is mounted on pontoon properly for lagoon applications.

 6.

 DO 

Always Disconnect Pump From Power Source Before Handling.

  

DO

 always connect to a separately protected and properly grounded circuit.

  

DO NOT

 ever cut, splice, or damage power cord.

  

DO NOT

 carry or lift pump by its power cord.

    DO NOT

 use an extension cord with a submersible pump.

  7.

 DO

 install a check valve and a union in the discharge line for pit applications.

  

DO NOT

 use a discharge pipe smaller than the pump discharge.

 8.

 DO NOT

 use a submersible pump as a trench or excavation pump, or for pumping gasoline or other hazardous 

liquids.

 9.

 DO

 test pump immediately after installation to be sure that the system is working properly.

 10. 

DO

 cover pit with an adequate pit cover.

 11. 

DO

 review all applicable local and national codes and verify that the installation conforms to each of them. 

 12. 

DO

 consult manufacturer for clarifications or questions.

 13. 

DO

 consider a Two Pump System with an alarm (See FM0532) where an installation may become overloaded or 

primary pump failure would result in property damages.

YOUR ASSURANCE 

OF QUALITY 

LIMITED WARRANTY

Manufacturer warrants, to the purchaser and subsequent owner during 

the warranty period, every new product to be free from defects in material 

and workmanship under normal use and service, when properly used 

and maintained, for a period of one year from date of purchase by the 

end user, or 18 months from date of original manufacture of the product, 

whichever comes first.  Parts that fail within the warranty period, one year 

from date of purchase by the end user, or 18 months from the date of 

original manufacture of the product, whichever comes first, that inspections 

determine to be defective in material or workmanship, will be repaired, 

replaced or remanufactured at Manufacturer's option, provided however, 

that by so doing we will not be obligated to replace an entire assembly, 

the entire mechanism or the complete unit.  No allowance will be made 

for shipping charges, damages, labor or other charges that may occur 

due to product failure, repair or replacement.

This warranty does not apply to and there shall be no warranty for any 

material or product that has been disassembled without prior approval 

of Manufacturer, subjected to misuse, misapplication, neglect, altera-

tion, accident or act of nature; that has not been installed, operated or 

maintained in accordance with Manufacturer's installation instructions; 

that has been exposed to outside substances including but not limited to 

the following:  sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon 

derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive 

substances, wash towels or feminine sanitary products, etc. in all pump-

ing applications.  The warranty set out in the paragraph above is in lieu 

of all other warranties expressed or implied; and we do not authorize 

any representative or other person to assume for us any other liability in 

connection with our products.

Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky  

40211, Attention: Customer Service Department to obtain any needed 

repair or replacement of part(s) or additional information pertaining to 

our warranty.

MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPE-

CIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH 

OF EXPRESSED OR IMPLIED WARRANTY; AND ANY IMPLIED 

WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND OF 

MERCHANTABILITY SHALL BE LIMITED TO THE DURATION OF THE 

EXPRESSED WARRANTY.

Some states do not allow limitations on the duration of an implied war-

ranty, so the above limitation may not apply to you. Some states do not 

allow the exclusion or limitation of incidental or consequential damages, 

so the above limitation or exclusion may not apply to you.

This warranty gives you specific legal rights and you may also have other 

rights which vary from state to state.

Содержание 4290

Страница 1: ...ANED PERIODICALLY Water stream will be visible from this hole during pump run periods 1 Make sure the terminal or control box is properly grounded and contains a grounding lug for the pump All pumps are fur nished with provisions for proper grounding to help protect you against the possibility of electrical shock Outside installation require a NEMA 3R or 4X enclosure per the NEC 2 Make sure the pu...

Страница 2: ...ranty period every new product to be free from defects in material and workmanship under normal use and service when properly used and maintained for a period of one year from date of purchase by the end user or 18 months from date of original manufacture of the product whichever comes first Parts that fail within the warranty period one year from date of purchase by the end user or 18 months from...

Страница 3: ...ble from drooping and entanglement with lagoon debris 5 Three phase pumps require motor starters Refer to Zoeller FM0825 6 Voltage at the terminal point of the power supply line must be 90 or greater than the motor rated voltage when pump is running Ex 200 208V pumps must have 180 187V at the termination point ter minal box 230V pumps must have 207V at the termination point These voltages are requ...

Страница 4: ...ake for scale Remove baseandinspect Ventholeispluggedandpumpisairlock ing low voltage incorrect motor rotation 3 phase pumps check base and impeller for deterioration and wear A Pump will not start or run B Motor overheats and trips overload or blows fuse circuit breaker C Pump starts and stops too often or will not shut off Pit installations D Pump operates but delivers little or no water or loss...

Отзывы: