Zoef Robot Rob MR08Z, Инструкция пользователя

Страница: 80 / 83

Troubleshooting:
1. The mower does not start.
a) The mower starts in an ineffective fence line area. Check the fence line for repair.
b) Check the emergency stop switch. If the emergency stop switch is locked, press the emergency stop
switch then press red power switch.
c) If the mower has not been used for a long while, the battery may be empty. Make sure to charge it again after
charging. Even when unused, it is recommended that the battery is charged every 3 months.
2. The mower does not move forward .
a) The bumper might be stuck. Please turn off the mower and check the bumper. If the bumper was broken or the sensor
tube was sheltered by dirt, please use thing to clean it. if the switch is returned to the start position after being pushed. If
it can not be back to position when push you should remove possible objects or grass that has been stuck in the bumper.
b) If the grass is very long at the first time, which will shelter the sensor tube, please mow the grass with a traditional
lawn mower before using the robot mower.
3. The mower does not mow properly or at all.
a) Turn off the mower. Check if the blades are properly installed.
Replace the blades if damaged.
b) If the mower is in a slope which has an angle more than 45 o, the mower will automatically stop.
c). The root part of the blade holder is stuck by objects or grass. Remove them and restart.
d) The grass is too dense to be mowed due to the automatic protection of machine.
4. The mower crosses the fence line and continues outside the perimeter.
a)The fence line turn angle is too steep. The inner angle must be at least 125 o.
b) The fence line is too close to a slope. Adjust the fence line position to be in accordance to the
recommendations.
C) The fence line signal is weak. The fence line must not exceed 200m.
5. The battery is not charging.
a) The extruding poles of the charger are not in contact with the paddles of the charging station.
b) The extruding poles or the paddles are dirty. Clean them. (Make sure to disconnect the power before
cleaning.)
c) If long time no charge, the left power will be exhausted by itself. If the battery broken a little you can
re
- charge many times to active the battery or you can change the battery
.
6. The mower does not return to the charging station for charging.
a) The fence line is too long. The battery lever is not enough to return the mower to the charging
station. Turn off the mower and carry it to the station.
b) If the mower was stopped by obstacle it will stop working