1 6
3 / Installation
FROM CLEANER TO FILTRATION SYSTEM :
EXAMPLE OF INSTALLATION ON A SKIMMER
1
INSTALLATION
•
Make sure the skimmer, pump basket and filter are clean.
•
Adjust the inlet jets so that they point towards the bottom of the pool.
•
Close the main drain on the bottom of your pool.
•
Turn on the pool drain.
•
Fill the G2 hose with water using the flow from the inlet jets ensuring that
the hose remains beneath the surface of the water during and after these
procedures
(Schema C)
.
IMPORTANT : You can connect your G2 to a (or the) skimmer point,
or to the vacuum point. You are strongly advised to connect it to
a skimmer point for maximum cleaning efficiency.
2
CONNECTION
POOLS WITH ONE SKIMMER AND NO VACUUM POINT
In pools fitted with only one skimmer it is advisable to use a flow control valve.
Use a weir adapter to fit the automatic flow control valve to the skimmer
(Schema D)
.
IMPORTANT :
The automatic flow adjustment valve is pre-set in the factory
to number 3, the most suitable position for European pools. For an optimal
performance from your cleaner, we recommend that you do not move the
valve from this position. Secondly, always check that the valve’s dark grey flap
is not held in the open position by the red lever - otherwise your cleaner
cannot function.
IMPORTANT : The valve must be under the water at all times,
otherwise air will be sucked into the pump.
POOLS WITH TWO SKIMMERS
Connect the hose or skimmer socket located in the main part of the pool.
Then adjust the suction of the shallow end skimmer so that the automatic pool
cleaner will move around at normal speed 5 to 6 meters per minute).
POOLS WITH VACUUM POINT
Connect the automatic pool cleaner to the vacuum point and then adjust the
flow using the skimmers as described above.
YOU MUST : Use the pool pulse to check the flow after making
any connection.
Schema C
Schema D
G2 2010.qxd 23/02/10 9:30 Page 15