ZX340Q Series User Guide
Page
7
TROUBLESHOOTING
Hardware Diagnostics
1.
Restart your computer in DOS mode.
At the command prompt, run the diagnostic program that came with your adapter. For
example:
Adapter
Diagnostic Program
Type This
NetBlaster ZX345
diag345.exe
diag345 list
NetBlaster ZX345Q
diag345q.exe
diag345q list
NetBlaster ZX346
diag346.exe
diag346 list
NetBlaster ZX346Q
diag346q.exe
diag346q list
NetBlaster ZX348
diag348.exe
diag348 list
NetBlaster ZX348Q
diag348q.exe
diag348q list
For example, if you have a NetBlaster ZX346Q, then run this command from DOS:
diag346q list
You will see a report listing the current status of each active PCI device on your host
computer's PCI bus. Note the
bus
and
device
numbers corresponding to your adapter. You
will need these numbers when installing your software driver.
Note: If you do not see the listing, you will need to initialize your adapter using the following
command:
ppbinit all
to initialize the PCI-PCI bridge chip in your host computer system. This utility is supplied on
your driver diskette.
2.
To test an adapter, use your adapter's diagnostic program and specify the
bus
and
device
numbers; see the list command (above).
For example, if your four-channel NetBlaster ZX346Q is on bus 1, the device numbers may
be 4, 5, 6 and 7. To test all four channels, your commands would be:
diag346q 1 4
diag346q 1 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
