11
5.2.1 Hardware Installation
Follow the steps below to set up your camera hardware connections. Make
sure to follow each step carefully to ensure that the camera operates properly.
Affix the antenna to the back of the camera.
Plug the network cable into the camera and then into your
Cable/DSL router.
Plug the power adapter into the camera and then into the power
outlet (surge protector recommended).
The camera takes approximately 30 seconds to start up before it
displays an IP address on the 'Search Devices' program.
When the camera is powered on and the network cable is plugged
in correctly, the small green light on the network jack will turn on
and the small yellow light will flash.
CAUTION
:
Make sure to only use the power adapter supplied with the IP
CAM. Using a non-approved power adapter may damage the camera and void
warranty.
5.2.2 Software Installation
