ZLP Electronics DigiMaster Audio-DATA interfaces, Инструкция по использованию

Страница: 3 / 6

DigiMaster DUAL Channel USB Audio-Data Interface.
The dual channel usb interface provides the user with two independent “virtual”
comports.
Channel “A” is normally installed by Windows as the lower numbered virtual comport.
Channel “B” is normally installed by Windows as the higher numbered virtual comport.
The audio interface is controlled by channel A. RTS can be used to activate your radios
PTT line. If your interface has CW option then DTR is used for CW. If your CW cable has a
“marker” at one end, then this end of the cable should be plugged into the unit.
You can run any digimode software on channel A as though you where using any audio
interface, simply configuring your software to suit the number of the virtual comport,
RTS for PTT and DTR for CW (if fitted).
Channel “B” is the CAT – CIV connection to the radio, the dual channel interface supports
Icom/Yaesu or Kenwood, jumpers inside the unit select Icom / Yaesu or Kenwood.
Both jumpers are to the left for Icom and Kenwood, both to the right for Kenwood.
When holding the PCB with the components and connectors uppermost. The USB
connector on the left.
The CAT – CIV settings are dependant on your radio make and model.
Refer to your operating manual for instructions how to configure your CAT software.
Generally, for Icom radios you will need to set;-
CIV address, baud rate, comport (virtual comport), radio model.
And for Yaesu radios, baud rate and comport (virtual comport) and radio model.
Since the dual channel unit has a separate CAT channel, you can run different CAT
software at the same time as your digimode software.
Driver installation is not automatic, but it is straight forward, simply install the driver
from the CD supplied or download the driver from the site along with the detailed driver
installation instructions.
USB Drivers