Zline RA24, Руководство по установке и инструкция пользователя

Страница: 17 / 46

9
Installing the chains
The chains shipped with the range must be properly secured to the rear wall, as
shown in the picture on the following page. The height of the bracket from the floor
must be determined after the range legs have been adjusted to the desired height and
after the range has been leveled. If the chain length is too short to properly secure the
range to the rear wall, ask the installer to lengthen it.
1. Measure the distance from the floor to the where the chains connect on the back of
the appliance.
2. Position the ends of the chains on the wall at the desired height plus 1/8 (0.32
cm). The chains must be placed at 2 & 5/16” (6.0cm) from the side of the range. The
distance between the two chains is 25 & 1/4 “(64.1 cm).
3. Secure the ends of the chains to the wall with appropriate hardware.
4. Slide the range against the wall.
5. Check to see that the chains are connected properly. Then grasp the top rear
edge of the range and carefully attempt to tilt it forward. Verify that the chains are
engaged.
6. Or tighten the chains up with fixed screws on the wall. If the wall is not suitable for
installation, then the chains should be fixed to the cabinet structure.
Installing Chains
A child or adult can tip the range and be fatally injured; Adjust the
chains if the range is moved. Failure to do so can result in death or
serious injury.
WARNING
Installing the Anti-Tip
Stability Device