4
INSTALLATION
Trim Kit Installation
2. Remove the screws from the front bottom of your microwave. Using two of those
screws, secure the front bracket to the bottom of the microwave, ensuring the lip
of the bracket is extending down and facing you. Next, remove the screws from
the back bottom of the microwave and fasten the rear bracket, ensuring the two
small lips are extended down and facing back (see Figures 4 and 5).
Figure 4
Figure 5
3. Lay the outer trim face down and, using eight of the #2 screws, install the four
buckles on the corresponding mounting holes around the trim kit (see Figure 6).
Make sure to use the same series of mounting holes on each corner, depending
on your cabinet cutout (see Figure 7).
①
将安装好卡扣的外观框放在橱柜上作出比对；用记号笔画上安
装位置
②
用 1#螺丝将卡座安装在对应安装位置上
①
Use 2# screws to install the four buckles on the corresponding mounting
holes around the trim kit
使用
2#
螺丝将四个卡扣安装在外观框四周对
应的安装孔上
Place the trim kit which install buckle on the cabinet for
contrast, then use marker strokes to draw the mounting
position
Figure 6
Figure 7