ZKX Audio KW815, Руководство пользователя

Страница: 14 / 17

- page 13 -
#13
7. LCD DISPLAY SHOWING
CH 01 : Show choosing the 10th channel, this machine has 16 different channels fou choosing. Press the up key or down key
choosing the right channel.
803.90 MHz : Show now using the frequency is 803.90 MHz. The frequency of the receiver must same as the transmitter`s
frequency then it can work. Press the up key or down key to change the frequency.
A B : Show the directional of the signal choosing (DIVERSITY). When antenna A signal was weak, the receiver will immediately
change to antenna B to receive the signal, so make the signal no break.
- - D B : Showing signal level.
A F : Showing audio level direction.
1. Turn on the receiver, it will show the name of the factory.
2. After showing the factory`s name, go into the work state.
CH01 803. 90M
00d B AF
3. Pressing “ SET ” tune selector, come into the manual frequency select mode:.
TUNE 806. 00M
00d B AF
Pressing UP or DOWN function key to change
the its` frequency, it can step up or
step down 0.05 MHz.
4. Turn off the receiver, show the factorys` name, and then the LCD gone out.
When next time you turn on the machine, it will keep the frequency that last time you used itself.
8. SPECIFICATIONS
1. COMPREHENSIVE
Carrier frequency: UHF 800 Mhz
Frequency stabilization: lees than +/- 30 ppm
Dynamic range: more than 90 dB
Total harmonic distortion: less than 0.5%
Frequency response: 40 Hz—15KHz +/- 3 dB
Audio output level:
- Separate type:
0-- +/- 400mV
- Mix tipe: 0-- +/- 200mV
OPERATION MANUAL KW815 OPERATION MANUAL KW815