ZKTeco TF1600 ZKTeco, Быстрый старт

Страница: 9 / 10

Access Control Terminal Quick Start Guide
7
long beep.
After that the system returns to verification state, the Green LED blinks once every two seconds (the buzzer
has no beep).
Note :
You have to reboot device again to register management card if it’s operation timeout
. You can
use the Software to configure or modify the management card once it is registered.
Operation Timeout: When there is no operation after 15 seconds, the device will automatically return to
verification state.
Verification State: It is a state that for users to verify their identity and unlock the door. The Green LED
blinks once every two seconds (the buzzer has no beep).
You can add or delete users by swiping a management card for different times in a row:
•
By swiping the management card once, the system enters to single user enrollment state .
•
By swiping the management card five times in a row, the system enters to single user deletion state .
Note: the interval between each two swipes in a row should be less than 5 seconds
12. Enrolling an Ordinary User
To enroll an ordinary user by management card, the system will automatically generate an ID number to the
user and it enters to enrollment state.
Enrollment state: It is a state to enroll single users. The green LED blinks twice every three seconds, at the
same time the buzzer has two short beeps every three seconds.
Note : It is allowed to enroll one user only each time . Each user is allowed to enroll one ID card only
and 10 fingerprints at most .
To enroll a user, proceed as follows:
•
Swipe the management card once, The green LED blinks twice every three seconds, at the same time
the buzzer has two short beeps every three seconds, thus you can start user enrollment.
•
Press the same finger over the sensor three times or swipe a new ID card to the proximity area, if
enrollment succeeds, the Green LED is normally on for one second, the buzzer has one long beep; If it
fails, the Red LED is normally on for one second, the buzzer has one long beep. (Generally it is denied
if the card or the finger has already been enrolled or each press of fingers are not qualified enough,
please pay attention to place the finger in a right way)
•
The system returns to enrollment state and waiting to swipe the card or press new finger (three times)
to continue enrollment for the same user.
•
Swipe the management card once again to quit enrollment state, the system returns to verification state.
Please do the same to enroll new users by following above steps.
Note : If there is no operation for 20 seconds in enrollment state or enrollment of 10 fingerprints and one ID
card for the same user completed, the system automatically returns to verification state. Otherwise you have
to swipe management card once to quit enrollment state.