ZKTeco SBTL2000, Инструкция по эксплуатации

Страница: 9 / 17

Figure 2-3B
Mark out the screw hole centers of the stand, and the edge of the chassis bases on the ground according
to the sizes as shown on the figure 2-3A. Use a hammer drill to perforate M12 screw holes and then install
the screws. Place the swing barrier turnstile according to the sizes and positions as shown in the figure
before installation and fixation. Connect the online cables and perform the power-on test. If the test is OK,
tighten the screws.It is recommended that a warning line was marked out on the ground after the machine
is installed, so as to prompt the pedestrian to stand behind the warning line when swiping the card. As
shown in Figure 2-3C:
Figure 2-3C