ProBio Installation Guide
15
How to Place a Finger on the Sensor?
Note:
ZKTeco’s fingerprint readers will give optimal results for fingerprint matching, if the
following recommendations and suggestions are followed.
Select a finger to enroll
It is recommended to use an index finger or a middle finger.
Thumb, ring or little finger is relatively difficult to place in correct
position.
How to place a finger on a sensor
Place a finger in a way that it completely covers the sensor area with
maximum contact.
Place the core of a finger at the center of the sensor. The core of a
finger is the center where the spiral of ridges is dense (usually the
finger core is at the opposite side of the lowest point of the nail).
Place a finger in a way that the bottom end of a nail is located at the
center of the sensor.
DO NOT place the finger in the following positions
Upright
Skewed
Sideways
Partial
ProBio
Содержание ProBio
Страница 8: ...ProBio Installation Guide 7 Direct Connection Direct Connection Ethernet Cable Network Cable Adapter...
Страница 14: ...ProBio Installation Guide 13 Third Party Controller Wiegand Output Connection ProBio ProBio ProBio ProBio...
Страница 15: ...ProBio Installation Guide 14 How Does It Work The working principle of ProBio device is shown below...