Plock 2 User Manual P a g e |
3
Installation tool:
Impact drill, drill bit No. 8, No. 8 expansion screw, hex wrench, ordinary hammer.
Installation steps:
1. Pull up the arm of the parking lock, unlock and remove the top cover.
2. Determine the parking lock installation position, and place the parking lock in the position.
3. Use a pen to mark three holes to facilitate drilling.
4. Drill three holes with diameter of 12mm and depth of 50mm with the model M12 drill bit according
to the positions of the three mounting holes, and knock the expansion bolt M8 into the hole, then
remove the nut.
5. Thread the three holes through the expansion bolt and tighten the nut.
6. Connect the battery plugs and lock the top cover.
7. Start operating the parking lock. If the parking lock operates normally, the installation is completed.
6.
Precautions for handling batteries
1. The product is not equipped with batteries. Please prepare regular alkaline dry batteries (D x 4).
2. Do not heat and disassemble the batteries, or they may explode or sink.
3. Do not reverse the electrical polarities.
4. Do not throw the batteries into fire.
5. Do not attempt to open the batteries.
7.
Cautions on use
1 When the batteries of the remote controller are dead, you must replace them with the same type of
batteries in time.
2 Keep the parking lock clean by removing dust and rubbish from it regularly.
