ZKTeco PB3000 Series страница 5 Скачать руководство пользователя

Страница: 5 / 7

PB3000 Installation Guide

Chapter 3 Boom Installation

Take out the booms.

Install the booms. (If your purchase is PB3010L/R, there will be only one boom. If your purchase is PB3030L/R

or PB 3060L/R there will be a main boom and a vice boom which need to be connected together. See figure

3-1.)

Putting the vice boom insert into the main boom, then fastened by 2 screws.

Installing the boom to the chassis, as shown in figure 3-2.

Figure 3-1

Figure 3-2 Installing the Boom to the Chassis

Connect the main boom with vice together by 2 screw

Screw

Iron piece

Boom

Содержание PB3000 Series

Страница 1: ...Installation Guide PB3000 ...

Страница 2: ...PB3000 Installation Guide 1 Contents Chapter 1 Cable Embedding 1 Chapter 2 Cabinet Installation 2 Chapter 3 Boom Installation 3 Chapter 4 Control board introduction 4 Chapter 5 Troubleshoot 5 ...

Страница 3: ... a tool to open a cable tray on the ground see figure 1 1 Figure 1 1 Cable embedding The power wire is wrapped and protected using the wire sleeve when laid out under the ground the strong current should be separated from the weak current Control room Screw pad Ground Ground Cabinet Expansion bolt 4 M12 Base concrete A standard power wire RVV3 1 0 A signal line RVV4 0 5 ...

Страница 4: ...cabinet 2 Drive four expansion bolts into the Bolt Holes Dimensioning as shown in figure 2 1 3 Open the access door and install the parking barrier 4 Install screw pads and use a wrench to tighten nuts as shown in figure 2 2 5 Close the access door Figure 2 1 Figure 2 2 Screw pad Ground Ground Base concrete Chassis Expansion bolt ...