It is recommended that the device must be installed on a horizontal solid platform with a height of
50mm to 100mm.
1.
After installation, check if the connection has been done correctly at the connecting points of the
ground wire, at the connector assemblies and wiring points of the circuits, as well as at each movable
part of the device. Any loose nuts, screws and other fasteners should be tightened in time to avoid any
failures caused by long-time operations.
4.
1
1 Installation Requirements
3.
Make sure the ground wire of the system is reliably connected to avoid personal injuries or other
accidents.
2.
It
is
also
recommended
that
the
device
should
not
be
used
in
the
corrosive
environment
.
2 Preparation
To install the device you must have:
A Screwdriver:
To remove or install the screw on the device.
A Pencil:
To mark the device size and the screw hole.
A Electric Drill:
To drill holes in accordance to the marked screw holes.
A Wrench:
To secure the M12 expansion screw on the device.
A Tapeline:
To measure the dimensions that need to be measured during the installation of the device.
A Hex Wrench:
To remove or install the screw on the device.
Except for the hex wrench, all other tools should be prepared on your own.
Note:
The FHT2300 series, FHT2300D series, FHT2400 series and FHT2400D series have only slight differences
in appearance, but the installation, wiring and use are the same, and the following is an example of
FHT2300 series.
Содержание FHT2300
Страница 10: ...9 Bottom Top Front...
