201 Circle Drive N, Suite 116 Piscataway, NJ 08854 Tel: 732-412-6007 Fax: 732-412-6008
www.zkaccess.com
Important Notes
Use regulated 12V DC 3A power source (supplied from control panel or separately
purchased power supply).
Please make sure to protect TF1700 against vandalism.
Mounting the Unit
Place the unit approximately 5 ½ feet above the ground level if permissible so that the
users are comfortable in using the reader with least chances of error
Pull the power and network cables from the back of the wall and connect them to the
appropriate pigtail wires supplied with the reader
Remove the screw at the bottom of the reader to detach the back plate.
Install the back plate of the unit on to the wall and connect the power, network and other
necessary cables on the back of the unit.
Secure the reader with the back plate by fixing the tamper proof screw at the bottom of the
reader.
Hardware Setup
Power on the reader by supplying 12V DC to the power and GND pins on the back of the
reader. The power supply is not supplied with the reader. Please make sure that the power
requirements are strictly met to avoid permanent damage to the reader.
After the reader is powered on, the display will show the date, day and time on the screen.
Date and Time Setup
To change the date and time, press the Menu key;
The Menu will then display.
Menu
►User Manage
Options
PenDrive Mng
Scroll with the
▲
/
▼
keys and place the cursor (►) alongside “Options”. Press the OK key.
Scroll with the
▲
/
▼
keys and place the cursor (►) alongside “System Opt”. Press the OK key.
Scroll with the
▲
/
▼
keys and place the cursor (►) alongside “Date Time”. Press the OK key.
Once in the YYYY-MM-DD 24H screen, use the
▲
/
▼
keys to move between data fields.
Set the data and time.
Press the OK key to accept changes.
Press the ESC key to cancel changes.
