User Manual for Models HG2, HP2, PSM and PSL.
Version 1.0
Page 15/17
Operational Procedure
1.
When removing four attached screws to install this product, please make sure not removing fan or
case screws by mistake.
2.
Tighten four screws onto the computer case and double check for stability. (Please refer to the
figure on page 4).
3.
Before connecting the units, make sure you verify connector and pin assignment for devices such
as motherboard, hard disk etc. For example, the pin assignments of 24-pin and 8-pin connector on
AMD Athlon MP Motherboard are totally different than Intel Xeon motherboard. Severe damages
may occur by wrong connection.
4.
Check product specifications and calculate actual current requirements of each DC voltage. Make
sure these requirements fall within the minimum and maximum range of power supply. If the
current requirements are below the minimum load spec., the power supply may not start up. If the
current requirements are over the maximum load spec., our over protection circuitry will latch and
shutdown the power supply.
5.
Plug in power cord to the inlet of power supply.
•
Only HG2 models have line power I/O rocker switch. Please set the switch to “I” or “ON”
to turn on line power. For other models, just plug the power cord into the electrical outlet
directly.
•
Active Power Factor Correction (PFC) function is available for all power supply models
listed in this manual. The PFC function ensures maximum efficiency of power usage to
preserve energy and lower your electrical bills. It also automatically adapts to a very wide
range of AC line voltage: 100V to 240V AC. (There are no manual switches for you to
select AC input). This unique design ensures you can use our power supplies anywhere in
the world.
6.
You can start up the power supply remotely by using “Remote on”.
