TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Seite 33
TISCHKREISSÄGE / TABLE SAW ZI-TKS 250H / ZI-TKS 250-2VB
ite 33
16
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
PROBLEM
CAUSE
SOLUTION
Excess vibration
Blade is out balance
．
Blade is damaged
．
Saw is not mounted securely
．
Work surface is uneven
．
Blade is warped
．
Replace blade
．
Replace blade
．
Tighten all hardware
．
Reposition on flat surface
．
Replace blade
．
Rip fence does not
move smoothly
．
Rip fence not mounted correctly
．
Rails are dirty or sticky
．
Clamp screw is out of adjustment
．
Remount the rip fence
．
Clean and wax rails
．
Adjust clamp screw
．
Rip fence does not
lock at rear
．
Clamp screw is out of adjustment
．
Adjust clamp screw
．
Cutting binds or
burns work
．
Blade is dull
．
Working is fed too fast
．
Rip fence is misaligned
．
Spreader is out of alignment
．
Wood is warped
．
Replace or sharpen blade
．
Slow the feed rate
．
Align the rip fence
．
Replace the wood
．
Always cut with
convex side to table surface
．
Wood edges away
from rip fence when
ripping
．
Saw does not make
accurate 90ºor 45º
cuts
．
Ripping fence is misaligned
．
Positive stops inside cabinet need
adjusting(Bevel Cuts)
．
Miter gauge is misaligned(Miter Cuts)
．
Check and adjust the rip fence
．
Adjust positive stops
．
Adjust the miter gauge
．
Height/bevel
adjusting handwheel
is hard to turn
．
Gears or post inside cabinet are clogged
with saw dust
．
Clean the gears or screw post
．
Saw does not start
．
Motor cord or wall cord is not plugged
in
．
Circuit fuse is blown
．
Circuit breaker is tripped
．
Cord or switch is damaged
．
Plug in motor cord or wall cord
．
Replace circuit fuse
．
Reset circuit breaker
．
Have the cord or switch replaced
．
Blade makes poor
cuts
．
Blade is dull or dirty
．
Blade is wrong type for cut being made
．
Blade is mounted backwards
．
Clean, sharpen, or replace blade
．
Replace with correct type
．
Remount blade
．
Blade does not lower
when turning height
/bevel adjusting
handwheel
．
Locking lever is not at full left position
．
Move locking lever to left
．
Motor labors in rip
cut
．
Blade not proper for rip out
．
Change blade; rip blade typically has
fewer teeth
．
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Autogoods “130”
130.com.ua