Zipper Mowers ZI-HS8, Руководство пользователя

Страница: 13 / 28

ZI-HS8
LOG SPLITTER OPERATION
7
PREHEAT HYDRAULIC OIL
While operating under extremely low tempe -
rature, keep the log splitter running under no
load for 15 minutes to preheat the hydraulic
oil.
CHECK 2-HAND OPERATION FUNCTION
Before initial operation, check to be sure the
two-handed operation is properly functioning
by following steps:
:: Lower both control levers, splitting
wedge lowers to approx 5cm above
the take above the highest table
position.
:: Release either of the levers, splitting
wedge should remains in the original
position.
:: Release both levers, the ram should
rise to the highest position
automatically.
SET WEDGE RAM STROKE
Before initial operation, check to be sure the
two-handed operation is properly functioning
by following steps:
CHECK ONCE AGAIN THAT THE OIL TANK CO -
VER SCREW IS LOOSENED (SEE PICTURE J)
AND AIR CAN CIRCULATE! FAILURE TO DO SO
DAMAGES THE HYDRAULIC SYSTEM ANDREN-
DERS WARRANTY CLAIMS NULL AND VOID!
:: Move splitting wedge to desired
position. The upper position of the ram
wedge travel should be about 3~5cm
over the logs to be split.
:: Release a control lever or switch off
motor.
:: See picture H . Release the Setscrew
(A) with L key.
Raise Adjusting Rod (B) until adjusting
rod (B) is started to be stopped by the
spring inside. Tighten the Setscrew(A).
LOG SPLITTING
Place the log onto the splitter base / support
table vertically and sitting flat on it. Be sure
the wedge and base/table will contact the log
squarely on the ends. Never attempt to split a
log at an angle.
Adjust the Log Holders (A) according to the
diameter of the log to obtain most comfortable
Control Levers angle. See picture I .
See picture K : Hold the log with clamping bra-
ckets closely in the control lever guards. lower
levers to start the splitting. Releasing either
lever stops the motion of the splitting wedge.
Releasing both handles to return the splitting
wedge to the upper position.
Accumulated split wood and wood chips
can create a hazardous work environ-
ment. Never continue to work in a clut-
tered work area which may cause you to
slip, trip or fall.
STACK THE MATERIAL
Stack as you work. This will provide a safer
work area, by keeping it uncluttered, and
avoid the danger of trip
MAINTENANCE
8
REPLACING HYDRAULIC OIL
The hydraulic system is a closed system with
oil tank, oil pump and control valve. Check oil
level regularly with dipstick. Low oil levels can
damage the oil pump. Oil Level should mea -
sure approx. 1 ~ 2 cm lower than the upper
surface of the oil tank. The oil should be com-
pletely changed once a year.
The oil tank has a capacity of 6 liters.
:: Make sure moving parts stops and the
log splitter is unplugged.
:: Make sure that no dirt or debris finds
its way into the oil tank
:: Collect used oil and recycle.
:: Following an oil change, activate the
log splitter a few times without
actually splitting.
Following hydraulic oils or equivalent are re -
commend for the log splitter’s hydraulic trans-
mission system:
SHELL Tellus 22
MOBIL DTE 11
ARAL Vitam GF 22
BP Energol HLP-HM 22
Please maintain your log splitter well and ona a regu-
lar basis. Insufficient maintenance shortens your log
splitters lifespan decisively.
Repairs have to be carried out by qualified technici -
ans only. If a part needs to be exchanged, use origi -
nal ZIPPER parts only!
EN