OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
29
ZI-KM1000
13.2.2
Refuel
W A R N I N G
Use only unleaded fuel with min. 91 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE
Refuelling only outdoors!
Before removing the filler cap, turn the engine off and let it cool machine
Clean the fuel filler cap area
Remove the filler cap carefully
Fill in fuel
Fuel tank capacity: 1,0 l. Fill tank only up to 1,5 cm below the rim of the
filler neck, so that the fuel has place for expansion.
Replace and tighten the filler cap
Wipe any fuel residues and wait until it evaporates
13.3
Operating
13.3.1
Start Engine
Start the engine, if you have your machine mounted correctly:
1.
Set throttle to position CHOKE
2.
Pull the primer several times so that the carburettor is filled with gasoline.
3.
Pull the starter handle, pull-out until resistance is felt. Let the rope rewind slowly across and then
move expeditiously.
4.
Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
5.
After a few seconds engine run set the throttle to position START.
6.
Regulate the throttle until the engine is running smoothly.
To start the engine is warm the throttle is not be set to position CHOKE. If the engine will
not start repeat the procedure at point 1.
13.3.2
Stop the engine
1.
Set throttle to neutral position MIN and let the
engine run for approx. 30 sec. to cool down.
2.
Set throttle to position OFF (AUS)
