SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
16
ZI-EBM40V-AKKU
Work on electrical components or equipment may only be carried out by a qualified
electrician or carried out under the guidance and supervision of a qualified Electrician.
11.3
Safety instructions
In order to avoid malfunctions, damage and health hazards when working with this machine, in
addition to the general rules for safe working, the following measures in particular must be observed
UNCONDITIONALLY:
Check the machine for proper condition before each use. Make sure that all guards are in place
and in working condition and make sure that all screws, nuts, etc. are tightened. Do not
operate the machine if you notice that parts are missing or damaged!
Ensure sufficient lighting conditions in the working and surrounding area of the machine.
Keep your hands and feet away from moving machine parts and always ensure a secure stand
when working.
Remove the setting tool from the machine before switching on.
Never leave the running machine unattended (always switch the machine off before leaving).
Ensure that unauthorised persons maintain an appropriate safety distance from the machine,
and in particular keep children away from the machine.
The machine may only be operated, maintained or repaired by persons who are familiar with it
and who have been informed of the risks involved in this work.
Always wear suitable personal protective equipment (hearing protection, safety shoes etc.)!
Do not work on the machine if you are tired, unconcentrated or under the influence of
medicines, alcohol or drugs!
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
Do not use a machine whose switch is defective. A machine that can no longer be switched on
or off is dangerous and must be repaired
Do not overload the machine. Use the machine intended for the job. With the right machine
you will work better and safer in the specified power range.
Only use spare parts and accessories recommended by Zipper machines.
11.4
Special safety instructions for the operation the machine
Wear solid and non-slip shoes when working. Slips/stumps/falls are a major cause of serious
or fatal injuries.
Only use drills or mixers approved for the machine!
Never use damaged drills or mixers!
Earth borers/mixers may only be used in the vertical position (borer/mixer down)!
The machine must be held with both hands while working
Before each use, check the operational safety of the machine (tight fit of the tool, correct
function)
Before starting, after failure or impact, check the appliance and make sure that it is in good
condition
Do not wear jewellery or loose clothing that could be caught by the machine. Keep long hair
away from the air sampling openings.
Check the area where the machine is used and remove stones and wires that could be caught
by the machine to avoid causing danger to persons.
Do not operate the machine if persons (especially children) or animals are in the immediate
vicinity.
Ensure that there are no electrical cables, water pipes, gas pipes in the ground in the working
area.
Remove tall grass, bushes etc. from the working area. These could otherwise wrap themselves
around the drill!
Disconnect the plug from the socket and/or remove the battery before making machine
adjustments, changing accessories or putting the machine away. This precaution prevents the
machine from starting unintentionally
