OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-HET40V-AKKU
Checking the chain lubrication:
Start the machine.
Hold running saw chain for some time approx. 15 cm above a suitable surface. If there is
adequate chain lubrication, the oil which is ejected by the saw chain will form a light trail.
13.2.2
Checking the chain tension:
CAUTION
The teeth on the saw chain are very sharp! Wear protective gloves when
performing any work on the chain. Risk of injury!
NOTICE
Check and re-adjust the tension of a new chain after working for a few minutes.
Checking the chain tension:
The saw chain must not sag, but it should be possible
to pull it 2-3 mm off the saw rail in the middle of the
saw rail.
Tensioning the saw chain:
Unscrew the handwheel anti-clockwise until the saw
rail can be moved by hand (1.).
Turn the chain tensioning wheel on anti-clockwise
to tension the chain (2.).
Turn the saw chain by hand to check that it runs
perfectly. It must slide freely in the rail.
Tighten the handwheel to attach the rail and the
cover (3.).
13.3
Operation
Assembling and adjusting the shoulder belt:
Open retaining hook and hook onto the fastening
eye on the housing.
