Page 6 of 8
81333 v1.12 09.21 Tudor Installation Instruction
Control Panel
Water Temperature
Zip Tudor water heaters are fully automatic, and may be left switched ON under the control of the variable
thermostat.
Nominal operating temperature can be varied from about 30°C to about 80°C.
Temperature should not be set to less than 50°C without due regard to regulations governing the storage
temperature of hot water.
Economy Setting
The economy setting “E” will maintain stored water temperature
at approximately 50°C. At the “E” setting, the temperature control
locates into a set position and a slight resistance will be felt when
rotating the temperature control beyond that setting. This measure
is to help ensure that higher temperatures are only selected
deliberately.
Frost Protection
If the heater is located where ambient air temperature could fall below 5°C when the heater is not in use, the
“anti freeze” setting on the temperature control will maintain stored water temperature over 5°C to prevent
freezing and damage to the water heater.
The same protection does not extend to connecting pipework or fittings.
Safety Cut-out
Should the heater over-heat, a manually resettable safety cut-out will automatically turn the heating element
OFF. The cut-out must be reset by a Zip Service Provider or a licensed electrician. Users should never reset
the cut-out without qualified assistance.
ANTI-
FREEZE
ECONOMY
HIGH
OFF
LOW
Operation
Spare parts
Part no
Description
90836
Element kit (pre-August 2019)
90852
Gasket-New Style Element Kit Tudor 2010
90854
Thermostat Kit Tudor 2010
90855
Thermal Cut-Out Kit Tudor 2010
93816
Kit Mixer Tap G4 ARC / Tudor 4-In-1, 3-In-1
96409
Overload kit Tudor (August 2019 onwards)
99039
Restrictaflow Single Pack Restrictor Flow Reducer Tudor
99371
Disabled Lever Kit - Hero Tap 4-in-1 4in1, 3in1, 3-in-1 Mixer Tap Lever Only kit Tudor
