802698 - G4 User Guide - June 2015 - v2.00
Page 11 of 24
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Filter Reset] button.
4.
To set the filter life or edit filter usage,
refer to section G- Filter.
After replacing the filter, the counters should be reset
The Zip HydroTap is equipped with a self-calibrating program to adjust
for altitude. On start up, the controls take the system through a calibration
process. Once this mode is complet the system reverts back to normal
operation. If you would like to calibrate the system anytime after initial
installation, please follow the steps below.
1. Press the [MENU] button for main
menu.
2. Press the [Install] button.
3. Press the [Hot Calibration] button.
4. In the next screen, press [Calibrate] if
you want to start calibration.
Boiling Calibration Screen
3 - Boiling Calibration
(Boiling models)
Caution:
In general, boiling water units may vent steam from the tap
spout. Take care to avoid personal injury whenever this occurs.
1. Press the [MENU] button for main
menu.
2. Press the [Install] button.
3. Press the [Booster] button.
4. If a Booster is installed, select YES to
enable the Booster.
5. Dispense boiling water for a minimum
of 30 secs and check the outlet hose
from the Booster is warm.
6. Otherwise select NO, if no Booster is
installed
This function should only be considered when a Booster unit is installed.
G4 HydroTap Booster Screen
4 - Booster
(Boiling models)
NOTE:
Failing to make the correct selection for ‘Booster’ will effect product
performance.
2 - Filter Reset
(All)
LCD Screen operation - Section C
