Page 28 of 32
801530 - Zip HydroTap B, BA, BHA, BAHA, Installation Instructions - July 2014 - V1.08
Section 6
Commissioning
The HydroTap is now ready to be commissioned.
•
Turn on the power and water and check for any leaks
•
Familiarise yourself with the operation of the Tap, in preparation for use (See User Guide)
•
Follow the Installation instructions below (and review Section C of the User Guide).
•
After commissioning, the system may be customised by selecting further options in Section G -
Settings, within the User Guide.
1.
Turn the stop cock ON
2.
Press [Start] [Stop] buttons to start and stop the filter flush.
3.
Allow at least 10 litres of water to flush through the filter.
4.
Once the filter flush is finished, Turn the stop cock OFF
then press [Stop] to end filter flush mode.
5.
Press [Next] for the Boiling Calibration screen.
Have a bucket or similar container (not supplied) at the ready to hold a quantity of water that will be ejected
while the Filter Flush Mode is in operation. Open the filter access door on the front of the HydroTap and the
filter cartridge will be exposed. Located to the rear RHS of the cartridge is a flush line, approx 600mm long
and the flush line stop cock. Place the free end of the flush line into the bucket or container (not supplied).
NOTE:
at first commissioning, the system will select the filter flush screen automatically.
6.1
-
Filter Flush
Prepare filter flush as per instructions
and press START
03:01 PM, TUE 12, Feb 2013
Boiling
Zip
START
STOP
NEXT
OPEN Position
CLOSED Position
ON
OFF
G4 HydroTap Filter Flush Menu
Stop cock
operation
6.2
-
Boiling Calibration
Boiling Water
03:01 PM, TUE 12, Feb 2013
Boiling
Zip
To start press
Calibrate
button
To
Calibrate
Steam Vent
97.5
53.0
EL
•
Press the calibration button and the system will
commence the Boiling calibration procedure. This
will take aprox 5-6 minutes.
