2
INSTALLATION INSTRUCTIONS
T210025 V2.00 JUNE 2018 - ZIP FL064, FL104
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
INSTALLATION INSTRUCTIONS
Safety information
WARNINGS
• This product must be installed in accordance with local regulations and these installation instructions.
• Installation, commissioning and maintenance must only be carried out by a competent installer who will then be
responsible for adhering to all relevant standards and regulations.
• An approved check valve or other (no less effective) back flow device must be fitted between the supply and filter.
• The filter must not be modified in any way.
• In case of leaks isolate the water supply. Repairs must only be carried out by Zip or an authorised Zip service engineer.
• Incoming water temperature must not exceed 23°C.
• Only to be used with a Wholesome (cat 1) water supply.
• If the filter interferes with any earth bonding then a bonding strap should be fitted according to current IEE regulations.
!
!
!
CAUTIONS
• Optimum operation is ensured at a water flow pressure of 0.5-8.6 bar. Do not subject the filter to water hammer or
excessive pressure.
• The filter must only be used when correctly installed and in perfect working order.
• Flush the water supply pipes thoroughly prior to installation.
• Zip cannot be held liable for any damages caused by failure to observe these instructions.
• Filter performance is dependent upon age and site water conditions.
Technical specifications
• The filters are designed to reduce tastes and odours (including chlorine / chlorine by-products), THM’s, PAH’s,
pesticides such as Simazine, Atrazine, Lindane, Dieldrin and inhibit the precipitation of scale deposits.
• WRAS approved.
• Flow rate 2 - 3l / min.
• Temp. range 1 – 23
o
C.
• Water flow pressure of 0.5-8.6 bar.
• Capacity FL064 3000l nominal, FL104 6000l nominal.
• 15mm compression fittings.
Description
• A range of in-line filters, containing granular activated carbon and scale inhibitor.
Construction
• Filter casing
polypropylene.
• Internal grilles
polypropylene.
• Reticulated foam polyurethane.
• Particulate filters polyester.
• Media infill
granular activated carbon / polyphosphate.