Page 8 of 20
Hydro Tap Installation and Operating Instructions - 86682 - March 2012 v1.05
Step C - Connecting the tap
Model BC (boiling/chilled models)
Measure and trim the blue tube and connect it to the chilled water outlet
located on the top front, right hand side of the undersink unit. Use spring
clamps provided.
Measure and trim the red marked tube and connect it to the hot water outlet
located on the top centre, right hand side of the undersink unit. Use spring
clamps provided.
Measure and trim the unmarked tube and connect it to the vent outlet located
on the top centre, left hand side the top of the undersink unit. Use spring
clamps provided.
NOTE:
All tubes must have a continuous fall back to the
undersink unit.
Connect the tap USB connector to the USB lead on the undersink unit. Orient
the USB plug carefully and connect, do not force the plug. Once connected, fix
the cable to the wall, ensure it is away from any possible water splashes and
is off the floor.
Note:
When trimming any silicon tubes trim to minimum length, do not loop
any excess or allow kinking of the tubes. When connecting, slide the tube over
the pipe at least 25mm. There are black plastic clamps provided on the boiling
and chilled hoses to choke the flow if required. Only choke the flow if it is
excessively strong.
Model B (boiling only models)
Measure and trim the red marked tube and connect it to the hot water
outlet, on the top of the undersink unit. Use spring clamps provided.
Measure and trim the unmarked tube and connect it to the vent outlet on the
top of the undersink unit. Use spring clamps provided.
NOTE:
Both tubes must have a continuous fall back to the undersink unit.
Connect the tap USB connector to the USB lead on the undersink unit. Orient
the USB plug carefully and connect, do not force the plug. Once connected, fix
the cable to the wall, ensure it is away from any possible water splashes and
is off the floor.
Step D - Connecting an external filter.
BC160/125+ and BC200/175+ only.
(Not supplied as standard equipment).
To combat the build up of lime scale, a high performance external filter kit
may be ordered from your Zip service provider.
NOTE:
-
When fitted, the external filter will supply filtered water only for the Hot tank.
The internal filter will continue to supply filtered water for the cold tank.
-
The external filter may require the inlet water pressure to be regulated to
lower than 6 bar. In this case a 3.5 bar (350 kPa) Pressure Reduction Valve
will be required.
Installation Procedure
continued
Vent line
Chilled line
Hot line
Front
Vent
Hot Outlet
Rear panel with external filter fittings
BC120/60+
HOT outlet
Chilled outlet
USB and power
cable
Inlet
Vent
