7
5V and 2A
WAN/LAN: This port could be WAN or LAN port depending on the
configuration. It will be WAN port in router mode and LAN port in
bridge mode.
LAN: This port is always LAN in ZW-220. In Bridge mode, it bridges to WLAN
and “WAN/LAN” port. In Router mode, it bridges to WLAN only, In WISP
mode, it bridges to “WAN/LAN” port only.
Reset: Press Reset button to revert it to factory default.
Antenna: This SMA Reverse allows the user to connect antenna or RF cable.
At least connect an antenna to help ZW-220 to send and receive RF
signal.
ZW-220 integrates LNA/PA (Low Noise Amplifier) module and has at
lease 3dB RF sensitivity better than the regular WLAN products.
Hardware Installation
Once you check off everything from the package, you can start to install the
device. You can use the wall mount hole on the bottom of the device to
mount the device on the wall, or just put the device on the desktop. The
administrator can refer to the figure below while constructing your WLAN
environment.
