4
The Signal indicator should appear yellow and the Quality bar green.
Tuning will take about 35
seconds and the picture will automatically go to TV (normally TV1) when finished.
If the two indicators remain at zero then your Zinwell Freeview Receiver has failed to detect a signal
from the satellite and you will need to repeat the whole procedure from the beginning. If it fails on the
second attempt, then there is a problem with the signal reception from your satellite dish. We suggest
you contact an approved contractor for assistance. Thank you
After a restore to the Factory Defaults you may need to adjust the picture size as follows:
Widescreen Setup
1.
press
Menu
2.
use the
Down Arrow
until
System Configuration
is highlighted
3.
use the
Right Arrow
to move to the right sub menu, check that
System Setup
is highlighted and
press
Ok
4.
use the
Down Arrow
until
TV
is highlighted and press
Ok
5.
use the
Down Arrow
until
Aspect Ratio
is highlighted and then use the
left
or
right arrow
to
cycle through the three options:
4:3, 16:9
, or
PanScan
. Press
Ok
to save the option you have
selected and then press
Menu
several times to exit from the menu.
Older CRT TVs use the 4:3 setting and 16:9 is for widescreen TV models. An explanation of the “Pan
& Scan” mode can be found on Wikipedia.
I also recommend turning the volume up to 32 after a restore to Factory Defaults, especially if you record
from your ZMX-7500 or use the RF output rather than the CVBS (AV) or Component outputs.
Revision Date: 30 October 2011