2
Instructions Before Use
1. Inspection of all components for shipping damage or oil leakage. If any shipping damage is found, notify carrier at
once. Shipping damage is not covered by warranty. The carrier is responsible for all repair or replacement costs
resulting from damage in shipment.
2.
Oil feeding plugs
(Code No.5) are always shut tightly when in shipment and even in use because
the tanks are completely enclosed. Use them together with quick couplers with check valves.
3.
Check your power supply.
Power supply is AC110V or 220V 50/60Hz single phase. Make sure
that a grounded outlet or a plug adapter with a grounding attachment must be used.
4.
Check hydraulic oil.
Always check oil level before operation with the connected cylinders fully
retracted (extend if pull cylinders). In case oil is added with cylinders fully extended and then
cylinders are retracted, the returned oil will overflow in the reservoirs causing generation of high pressure in the
reservoirs. Verify required oil volume in a reservoir as follows:
a) Retract the connected cylinder fully.
b) Pull power plug out.
c) Turn oil feeding plug counterclockwise and remove it.
d) Clean the oil gauge of the removed oil feeding plug with a piece of cloth and put it in the oil feeding port again to
check oil level. BE CAREFUL WITH THE O-RING.
!
!
WARNING
!
WARNING
!
CAUTION
!
Description of Components
4.
33
10.63
.39 Ø .16
4.
15
.3
9
Ø
4
.3
7
(Ø
4
.7
2)
5.
31
12.68 (15.75)
6.
97
(7
.4
4)
2.
32
1.65
4.09
1. Oil Plug
2. Reservoir
3. Pump
4. Motor
5. Electric Cord
6. Switch
7. Handle
8. Release Valve
9. Output: 3/8" NPT
Specifications
*Remarks: 2L (usable oil: 1.6L) reservoir pumps are also available.
Model #
Electric Motor
Reservoir
Weight
1st Stage 2nd Stage 1st Stage 2nd Stage
…
70
0.6
0.3
Capacity
1.0L
Usable
0.8L
17 lb.
Commutator and
open type,
0.35KW 110V or
220V 50/60Hz
single phase, "E"
type insulation
2000rpm
ZPE-35RH-
1M(L)
Hydraulic Pump
Maximum Work
Pressure Mpa
Flow Rate L/min(50Hz)
Zinko Hydraulic Jack
Models: ZPE-35RH-1M & ZPE-35RH-1MB