ZiLOG Zdots eZ80AcclaimPlus, Руководство пользователя

Страница: 21 / 34

UM024401-0412 Running the Sample Starter Project
eZ80AcclaimPlus! Development Kit
User Manual
11
12. From the Build menu, select Set Active Configuration to open the Select Configura-
tion dialog box.
13. Select Debug , then click OK to close the Select Configuration dialog box.
14. From the
Project
menu in ZDS II, select
Settings
to open the Project Settings dialog
box. In the Project Settings dialog box, select the Debugger page.
15. In the Debugger page, select
eZ80F91ModDevKit_RAM
from the
Target
list.
16. In the Debugger page, select USB Smart Cable from the Debug Tool drop-down
menu.
17. Click OK to close the Project Settings dialog box.
18. If you are prompted to rebuild any affected files, click
Yes
. Otherwise, choose
Build
from the menu bar, then click Rebuild All .
19. To run the application, select
Go
from the
Debug
menu. Until the default settings are
changed, the following output will be presented in the HyperTerminal window:
Zilog Developer Studio
i = 5
d = 25
f = 1.260000
eZ80F91 5 25 1.260000
Viewing the Starter Project Output via the ZDS II Instruction Set
Simulator
The eZ80Acclaim! Cycle-Accurate Instruction Set Simulator interfaces with the ZDS II
Debugger to simulate the execution of programs without using an emulator or target hard-
ware. The Instruction Set Simulator uses the command set of the Debugger to perform
tasks such as simulating timers and interrupts.
To use the eZ80Acclaim! Instruction Set Simulator as an option, observe the following
steps to view the output of the
starter.zdsproj
project in the ZDS II IDE.
1. In ZDS II, open the
starter.zdsproj
project.
2. From the Project menu in ZDS II, choose Settings to open the Project Settings dialog
box. Click the
Debugger
tab.
3. In the Debugger dialog, select eZ80F91ModDevKit_RAM from the Target pane by
clicking the checkbox next to the specific target name. Next, select
Simulator
from
the Debug Tool drop-down menu.
4. Click
OK
to close the Project Settings dialog box.
5. If you are prompted to rebuild any affected files, click Yes . Otherwise, choose Build
from the menu bar, then click
Rebuild All
.