Zilarr
EN
3. Cleaning of sensor lens
Use soft cloth to gently wipe the sensors, positions indicated below:
Sensor
Sensor
-
Sensor
Battery replacement
1. Remove screws from battery cover at the unit underside with a screwdriver.
2. Remove cover and take out battery.
3. Slightly open the loek of the battery connecting pug to separate the battery from
the unit.
4. Connect the plug of the new battery with the socket of the unit.
5. lnsert the new battery with the face with the characters upwards.
6. Tuck the wires neatly near the battery and loek the battery cover.
7. Switch on and confirm the machine works normally.
Note:
• Only use a battery supplied or recommended by kogan
• Charge the new battery for 6 hours after replacement.
•
Please dispose of the old battery in an environmentally-friendly manner.
Troubleshooting
Issue
Cause
Steps to resolve
Red light flickers and buzzer
Earth inspection fault
Lift and replace on floor
sounds
Red lights Long bright
Drive wheels
Check left and right side
buzzer sounds
overloaded
wheels and brushes
Red lights flicker and
Collision switch fault
Check the flexibility of
the bumper
If an issue persists, turn the machine on and off at the switch on the base.
A
nd if this still does not resolve the issue, contact original factory support.