Version Number: MIG200-20210914A1
6
Note:
1) The welding rod specification supported by MIG200 is below 4.0(5/32in), usually 2.5(3/32in) and
3.2(1/8in). European style generally uses E6013, American style generally uses E7018, and stainless
steel generally uses ER308.
2) It supports welding of 1-8mm(1/64-5/64in) carbon steel and 1-5mm(1/64-7/32in) stainless steel.
Aluminum can not be welded. For carbon steel, please use carbon steel electrode. For stainless steel,
please use stainless steel electrode.
3) Connect the ground clamp to clean bare metal. No rust, paint or other coatings, and ensure good
electrical conductivity.
4) The ideal distance between the welding rod and the welding object is 1-2mm(1/64-5/64in), to ensure that
the welding rod and the workpiece are in continuous and stable contact. The welding rod should not
be too high or pressed too low to avoid arc breaking and adhesion.
5) It is normal for novices to have adhesion during the welding process, and you can try to friction arc to
avoid adhesion.
6) Suitable for ordinary welding rods, such as 7018, 6013, etc., but not suitable for special welding rods,
such as 7010, 7011.
Possible problems
1) There is no arc, check the ground wire to connect the workpiece to ensure that there is no rust, paint or
other coatings on the workpiece.
2) There is no arc, check the direct distance between the welding rod and the welding object, the ideal
distance is 1-2 mm; check whether the welding object has rust or oil stains, it is recommended to
polish with sandpaper or a grinder.
3) When welding, the spatter is very big, and it feels very difficult to weld. Please try to change the polarity
connection of the ground wire clamp and the welding clamp with the machine.
4) During the welding process, if the time exceeds 3 minutes, overcurrent protection may occur. You need
to stop working for a few minutes, let the machine cool down for a period of time, and automatically
recover. If the air cools for more than 10 minutes, the machine does not automatically recover, please
shut down and restart.
5) If you have any problems that cannot be solved, please contact us .
5.2 MIG mode
MIG200
provides two welding modes: gas shielded welding and self-shielded welding with fluxed wire. If you are
working at home or in a studio, in order to ensure a better welding effect, it is recommended that you use the gas
welding mode; if you need to go out to work, carry gas cylinders and other inconvenient situations, you can use the
Self-protected welding method.
1.1 Select “MIG ” process