ZIGOR ZGR TOWER PRO 6, Руководство по эксплуатации

Страница: 27 / 40

ZGR TOWER PRO 6 10 KVA
Operation manual www.zigor.com
27
Bypass Low Level switch setting (LLS)
Fig. 4-18 Bypass voltage lower limit setting
When under the bypass voltage upper limit setting press DOWN or when under parallel ID setting press UP, it
goes to the bypass lower limit setting. The bypass lower limit line flashes as in above picture (Fig. 4-18).
•
Use button ENTER/ON ( to set the different bypass voltage lower limit. The bypass voltage lower limit
range is 20%,30%,45%.
• Press ESC/OFF button to exit the bypass voltage lower limit setting (save the bypass voltage lower limit
setting) and goes to bypass upper limit setting or parallel ID setting.
Buzzer Mute Setting (bZ)
Fig. 4-19 Buzzers mute setting
Press DOWN under bypass voltage lower limit setting or press UP under the parallel ID setting can ENTER the
buzzer setting. Now the setting status is flashing as the Fig. 4-19 shows
NOTE: ON= buzzer active; OFF= buzzer mute.
Press ENTER again to stores change, then DOWN button until exit to save the settings.
Battery Test Setting (tSt)
Fig. 4-20 Battery self-test setting